|
1.
caution |
If replacing the transmission
with a new one, if overhauling the existing
transmission, or if the A/T fluid has
deteriorated or is contaminated, the A/T fluid
cooler line must always be flushed out.
|
Remove the hose shown in the illustration which
allows the A/T fluid to flow from the A/T fluid cooler to
the transmission. 2.
caution |
The engine should be stopped
within one minute of it being started. If the
A/T fluid has all been discharged before this,
stop the engine at that point.
|
Start the engine and discharge the A/T
fluid. Driving conditions: N range,
idling Discharge amount: Approx. 3.5
L 3.
caution |
Stop pouring in the A/T fluid
once 3.5 L has been poured in.
|
Pour in new A/T fluid through the oil filler
tube. Amount to add: Approx. 3.5
L 4.Repeat the operation in step 2 and
3.
note |
Carry out steps 2 and 3 so
that at least 8.0 L has been discharged from the
cooler hose. After this, discharge a small
quantity of A/T fluid and check for
contamination. If the A/T fluid is contaminated,
repeat steps 2 and 3.
|
5.Carry out the procedure in
"A/T Fluid Replacement" from step 2 onwards.
|