|
1.Set the special tools as
shown in the illustration so that they are pressed against
the
inner race of the one-way clutch.
- Spring compressor (MB991630)
- Spring compressor retainer (MD998924)
2.Screw in the special tool nut, and lightly
press against the inner race of the one-way
clutch. 3.Remove the snap ring.
|
|
1.Apply ATF to the
D-ring.
|
|
2.Install the D-ring in the
groove on the outer and inner periphery of the piston. Make
sure that the D-ring is not twisted or damaged when
installing.
|
|
Install the O-ring onto the center
support at the position shown in the illustration.
|
|
1.Set the special tools as
shown in the illustration.
- Spring compressor (MB991630)
- Spring compressor retainer (MD998924)
2.Screw in the special tool nut, and lightly
press against the inner race of the one-way
clutch. 3.Install the snap ring.
|