DISASSEMBLY AND REASSEMBLY

			Disassembly steps
<<A>>	>>C<<	1.	Snap ring
		2.	Plate
		3.	One-way clutch inner race
	>>B<<	4.	O-ring
		5.	Spring retainer
		6.	Return spring
		7.	Low/reverse brake piston
	>>A<<	8.	D-ring
	>>A<<	9.	D-ring
		10.	Center support

DISASSEMBLY SERVICE POINT

<<A>>SNAP RING REMOVAL

1.Set special tools as shown in the illustration so that they are pressed against the inner race of the one-way clutch.

Spring compressor (MB991630)
Spring compressor retainer (MD998924)

2.Screw in the special tool nut, and lightly press against the inner race of the one-way clutch.
3.Remove the snap ring.

REASSEMBLY SERVICE POINTS

>>A<<D-RING INSTALLATION

1.Apply ATF to the D-ring.

2.Install the D-ring in the grooves on the outer and inner periphery of the piston. Make sure that the D-ring is not twisted or damaged when installing.

>>B<<O-RING INSTALLATION

Install the O-ring onto the center support at the position shown in the illustration.

>>C<<SNAP RING INSTALLATION

1.Set special tools as shown in the illustration.

Spring compressor (MB991630)
Spring compressor retainer (MD998924)

2.Screw in the special tool nut, and lightly press against the inner race of the one-way clutch.
3.Install the snap ring.