![](../../../img/23/AK403391AB00ENG.png)
|
Use the special tools to remove the
snap ring.
- Spring compressor retainer (MD998924)
- Spring compressor (MD998907)
|
|
1.Apply ATF to the
D-ring.
|
|
2.Install the D-ring in the
grooves of the underdrive clutch retainer and spring
retainer.
Make sure that the D-ring is not twisted or damaged when
installing.
|
![](../../../img/23/AK403392AB00ENG.png)
|
Align the two return spring holes
with the two projections on the underdrive clutch piston,
and then assemble.
|
![](../../../img/23/AK403391AB00ENG.png)
|
Use the special tools to install
the snap ring.
- Spring compressor (MD998924)
- Spring compressor retainer (MD998907)
|
![](../../../img/23/AKX00146AC00ENG.png)
|
1.Alternately assemble the
clutch plate and clutch disc in the underdrive clutch
retainer.
Align and assemble the four clutch plates (where there are
no teeth) (A in the illustration) with
the underdrive clutch retainer hole (B in the
illustration).
|
![](../../../img/23/AKX00147AC00ENG.png)
|
2.Install the reaction plate
so that it is oriented as shown in the illustration.
Assemble
in the same manner as the clutch plate so that the section
with no teeth (A in the illustration) matches
the retainer hole (B in the illustration).
|
|
1.Install the snap ring in
the groove of the underdrive clutch retainer.
|
![](../../../img/23/AK403459AB00ENG.png)
|
2.Set special tools as shown
in the illustration, and compress the clutch
element.
- Spring compressor retainer (MD998924)
- Spring compressor (MB991629)
|
![](../../../img/23/AKX00149AC00ENG.png)
|
3.Check the clearance
(underdrive clutch end play) between the snap ring and
reaction plate
is the standard value. If the clearance is not at the
standard value, select the snap ring and
adjust so that the clearance is within the standard
value. Standard value: 1.6 - 1.8
mm
|