![](../../../img/27/AC602801AB00ENG.png)
|
1.Tighten the following
special tools in rear hub assembly to the specified
torque.
- Bolt (MB990999)
- Drag link bushing remover and installer A
(MB990843)
Tightening torque: 220 ± 10
N·m
|
![](../../../img/27/AC602802AB00ENG.png)
|
2.Measure the hub starting
torque by using the following special
tools.
- Torque wrench (MB990685)
- Preload socket (MB990326)
Limit: Less than 3.0
N·m 3.Hub starting torque must be
under the limit value and there should be no roughness when
rotating the hub.
|
![](../../../img/27/AC602801AB00ENG.png)
![](../../../img/27/AC602803AB00ENG.png)
|
1.Using the following
special tools, tightening rear wheel hub. Measure to
determine whether the wheel bearing axial play is within the
limit or not.
- Bolt (MB990999)
- Drag link bushing remover and installer A
(MB990843)
Limit: 0 mm 2.If the wheel
bearing axial play exceeds the limit value at the specified
torque of 220 ± 10 N·m, replace the rear hub
assembly.
|