![](../../../img/33/AC603512AB00ENG.png)
|
1.After shaking the ball
joint stud several times, use special tool preload socket
(MB990326) to measure the starting torque of the ball
joint.
note |
Rotation starting torque
measurement should be carried out with parts
temperature above 0°C.
|
Standard value: 1.0 - 6.9
N·m 2.If the measured value is not
within the standard value, or if the ball joint is difficult
to turn or does not turn smoothly, replace the lower arm
ball joint assembly. 3.When the measured value is
lower than the standard value, check that the lower arm ball
joint turns smoothly without excessive play. If there is no
excessive play, the ball joint can be reused.
|