|
Use the special tool accumulator
wrench (MB991926) shown in the figure to remove the
accumulator.
|
|
Use the special tool valve spring
compressor adapter (MB991620) and the spacer to hold the HBB
as shown.
|
|
- Push in the push rod of the power piston assembly,
and then use a small flat-tipped screwdriver to
remove the snap ring.
note |
If the snap ring can
not be released easily, use a pin to
push the snap ring out of the cylinder
body hole (A).
|
-
caution |
Do not damage the
cylinder wall.
|
Withdraw the power piston assembly and the
master cylinder piston assembly squarely from the
cylinder body.
|
|
Use the special tool accumulator
wrench (MB991926) to install the accumulator.
|