|
1.Remove the brake assembly,
and then hold it with wire.
|
|
2.Place a dial gauge
approximately 5 mm from the outer circumference of the brake
disc, and measure the run-out of the
disc. Limit: 0.06 mm or less
|
|
3.If the brake disc run-out
exceeds the limit, correct it as follows: (1)
Chalk phase marks on the wheel stud and the brake disc,
which run-out is excessive as shown. (2)
Remove the brake disc. Then place a dial gauge as shown, and
measure the axial play by pushing and pulling the wheel
hub. Limit: 0 mm <Front>, 0 mm
<Rear> (3)
If the axial play exceeds the limit, disassemble the hub and
knuckle assembly to check each part. (4)
If the axial play does not exceed the limit, dephase the
brake disc and secure it. Then recheck the brake disc
run-out. 4.Remove the brake assembly, and then
hold it with wire.
|