REMOVAL AND INSTALLATION


Post-installation Operation
  • Wheel Speed Sensor Output Voltage Measurement (Refer to ).




Front wheel sensor removal steps
<<A>>
1.
 Front wheel speed sensor


2.
 Rotor protector


3.
 Front rotor with driveshaft (Refer to GROUP 26, Driveshaft .)



Rear wheel sensor removal steps


4.
 Heat protector
<<B>>
5.
 Rear wheel speed sensor


6.
 Rotor protector


7.
 Rear rotor with driveshaft (Refer to GROUP 27, Driveshaft .)
note The front and rear rotors are integrated with the drive shaft and cannot be disassembled.

REMOVAL SERVICE POINTS

<<A>> FRONT WHEEL SPEED SENSOR REMOVAL

1.
caution Be careful when handling the projection at the tip of the wheel speed sensor and the toothed edge of the rotor so as not to damage them by contacting other parts.
Remove the three splash shield clips and the two bolts shown in the illustration, and then disconnect the front wheel speed sensor connector.
2.Remove the front wheel speed sensor.

<<B>> REAR WHEEL SPEED SENSOR REMOVAL
caution Be careful when handling the projection at the tip of the wheel speed sensor and the toothed edge of the rotor so as not to damage them by contacting other parts.