REMOVAL AND INSTALLATION <Short wheelbase, Long wheelbase-2 800, 3 000>

			Removal steps
<<A>>		1.	Rear brake caliper assembly
		2.	Rear brake disc
	>>D<<	3.	Shoe-to-anchor spring
		4.	Shoe guide plate
		5.	Adjusting wheel spring
	>>C<<	6.	Adjuster assembly
		7.	Strut
		8.	Strut-to-shoe spring
		9.	Shoe hold-down cup
		10.	Shoe hold-down spring
		11.	Shoe hold-down pin
		12.	Shoe and lining assembly
		13.	Parking brake cable connection
		14.	Shoe and lever assembly
	>>B<<	15.	Retainer
	>>A<<	16.	Wave washer
		17.	Parking lever
		18.	Shoe and lining assembly

REMOVAL SERVICE POINT

<<A>> REAR BRAKE CALIPER ASSEMBLY REMOVAL

Remove the rear brake caliper assembly and support it with wire or similar.

INSTALLATION SERVICE POINTS

>>A<< WAVE WASHER INSTALLATION

Install the wave washer in the direction shown in the illustration.

>>B<< RETAINER INSTALLATION

Crimp the retainer firmly to the pin with pliers.

>>C<< ADJUSTER ASSEMBLY INSTALLATION

Install the adjuster assembly so that the shoe adjusting bolt of left hand wheel is attached towards the rear of the vehicle, and the shoe adjusting bolt of right hand wheel is towards the front of the vehicles.

>>D<< SHOE-TO-ANCHOR SPRING INSTALLATION

caution

The shoe-to-anchor springs are not interchangeable, so be careful that the spring with the paint mark is installed at the vehicle’s rear side.

Install the shoe-to-anchor springs in the order shown in the illustration.