REMOVAL AND INSTALLATION <Long wheelbase-3 200, 3 800>

			Removal steps
<<A>>		1.	Rear brake caliper assembly
		2.	Rear brake disc
	>>C<<	3.	Shoe-to-anchor spring
		4.	Strut
		5.	Strut-to-shoe spring
		6.	Shoe hold-down spring
		7.	Shoe hold-down pin
		8.	Shoe and lining assembly
	>>B<<	9.	Adjuster assembly
		10.	Adjusting wheel spring
		11.	Shoe hold-down spring
		12.	Shoe hold-down pin
		13.	Parking brake cable connection
		14.	Shoe and lever assembly
	>>A<<	15.	Retainer
		16.	Parking lever
		17.	Shoe and lining assembly

REMOVAL SERVICE POINT

<<A>> REAR BRAKE CALIPER ASSEMBLY REMOVAL

Remove the rear brake caliper assembly and support it with wire or similar.

INSTALLATION SERVICE POINTS

>>A<< RETAINER INSTALLATION

Crimp the retainer firmly to the pin with pliers.

>>B<< ADJUSTER ASSEMBLY INSTALLATION

Install the adjuster assemblies so that the shoe adjusting bolt is mounted to the rear of the vehicle on the right and left rear wheels at the rear side of the vehicle.

note

For the adjuster assemblies, different parts are used for right and left rear wheels. Install the right-hand screw of the shoe adjusting bolt to the left rear wheel side, and the left-hand screw to the right rear wheel side.

>>C<< SHOE-TO-ANCHOR SPRING INSTALLATION

caution

The shoe-to-anchor springs are not interchangeable, so be careful that the spring with the paint mark is installed at the vehicle’s front side.

Install the shoe-to-anchor springs in the order shown in the illustration.