|
1.Place the front wheel on a
turning radius gauge and measure the steering
angle.
Standard value:
|
|
Item
|
Item
|
Specification
|
Inside
wheel
|
Short wheel
base
|
36°49’
±
1°30’
|
Long wheel
base
|
36°01’
±
1°30’
|
Outside wheel
(reference)
|
Short wheel
base
|
32°06’
|
Long wheel
base
|
32°18’
|
|
2.If the steering angle is not within
the standard value, adjust the toe-in as follows.
Standard value:
at the
centre of tyre tread: 0 - 5 mm
Toe
angle (per wheel): 0 ° 00’ - 0
° 12’
|
|
3.Adjust the toe-in by
undoing the clip and lock nut, and turning the left and
right tie
rod turnbuckles by the same amount (in opposite
directions).
| note |
The toe will move out as the
left turnbuckle is turned toward the front of
the vehicle
and the right turnbuckle is turned toward the
rear of the vehicle.
|
4.Tighten the lock nut to the specified
torque, and tighten the bellows by the
clip.
Tightening torque: 93 ± 15
N·m
5.Recheck the steering
angle.
|
