REMOVAL AND INSTALLATION

Removal steps 1. Fuel filler lid damper spring <<A>> >>A<< 2. Rivet <<A>> >>A<< 3. Fuel filler lid 4. Fuel filler lid lock release handle · Quarter trim, lower (Refer to GROUP 52A - Interior Trim .) 5. Fuel filler lid hook · Front scuff plate, cowl side trim, rear scuff plate, centre pillar trim lower, quarter trim lower (Refer to GROUP 52A - Interior Trim .) · Rear floor duct A <Vehicles with Dual A/C> (Refer to GROUP 55 - Duct <Dual A/C> .) 6. Fuel filler lid rock release cable

Use a drill (Φ 4.0 mm) to make a hole in the rivet to break it, and remove the rivet.

Use a rivet tool shown in the illustration to connect the parts with rivets by the following procedures. 1.Insert the rivet into a corresponding location. 2.Set the rivet tool at a portion A of rivet. 3.While pushing the flange surface of the rivet onto parts to be fixed with the rivet tool, press the handle of the tool. 4.Thin part of portion A of the rivet will cut off and the rivet is fixed in position.