REMOVAL AND INSTALLATION

Door window glass assembly removal steps >>A<< · Power window main switch <driver’s side>, power window sub switch <front passenger’s side> (Refer to GROUP 52A - Door Trim .) 1. Door belt line moulding assembly 2. Door window glass runchannel 3. Door window glass assembly 4. Glass holder Power window regulator removal steps >>A<< · Power window main switch <driver’s side>, power window sub switch <front passenger’s side> (Refer to GROUP 52A - Door Trim .) >>A<< 5. Power window regulator and motor assembly >>A<< 6. Power window motor assembly <<A>> >>A<< 7. Power window regulator assembly

Door window glass assembly removal steps >>A<< · Power window sub switch <rear side> (Refer to GROUP 52A - Door Trim .) 1. Door belt line moulding assembly 2. Door window glass runchannel <<B>> 3. Door centre sash 4. Door window glass assembly 5. Glass holder Power window regulator and stationary window glass removal steps >>A<< · Power window sub switch <rear side> (Refer to GROUP 52A - Door Trim .) >>A<< 6. Power window regulator and motor assembly >>A<< 7. Power window motor assembly <<A>> >>A<< 8. Power window regulator assembly 9. Stationary window glass 10. Stationary window weatherstrip

2. caution If any film or the like is applied to the door window glass, use the special tool window glass holder (MB990480) at the outside of the door glass to prevent the film from peeling off. Raise the door window glass, and attach the special tool to the glass as shown to prevent the glass from dropping. 3.Remove the power window regulator.

1.Remove the door outer opening weatherstrip from the door centre sash section only. 2.Remove the mounting screw for the door centre sash, and remove the door centre sash from the door panel.

When the following procedures are carried out, carry out the learning procedures of the power window fully closed position (Refer to ).