DISASSEMBLY AND REASSEMBLY

			Disassembly steps
		1.	Front bumper grille
		2.	Front fog lamp assembly <Vehicles with front fog lamp>
		3.	Front fog lamp bezel <Vehicles with front fog lamp>
		4.	Front fog lamp hole cover <Vehicles without front fog lamp>
<<A>>	>>A<<	5.	Rivet A
		6.	Front bumper side bracket
<<A>>	>>A<<	7.	Rivet B
		8.	Front bumper side reinforcement
		9.	Front bumper cover
		10.	Front bumper face

DISASSEMBLY SERVICE POINT

<<A>> RIVETS A/RIVETS B REMOVAL

Use a drill (Φ 4.0 mm) to make a hole in the rivet A and rivet B to break it, and remove the rivet.

REASSEMBLY SERVICE POINT

>>A<< RIVETS A/RIVETS B INSTALLATION

Use a rivet tool shown in the illustration to connect the parts with rivets by the following procedures.
1.Insert the rivet A or rivet B into a corresponding location.

note

Rivet A is used for vehicles with overfenders only.

2.Set the rivet tool at a section A of rivet.
3.While pushing the flange surface of the rivet onto parts to be fixed with the rivet tool, press the handle of the tool.
4.Thin part of section A of the rivet will cut off and the rivet is fixed in position.