REMOVAL AND INSTALLATION

	1.	Front three-diamond mark (Refer to .)
>>A<<	2.	MASCOT mark: Type A <Optional for vehicles for General Export and GCC: GLX>
>>A<<	2.	MASCOT mark: Type B <Vehicles for GCC: 3800 GLX>
>>A<<	3.	3.8V6 mark <Optional for vehicles for GCC: 3800 GLX>
>>A<<	4.	Rear three-diamond mark
>>A<<	5.	PAJERO mark
>>A<<	5.	MONTERO mark <Optional for vehicles for General Export>
>>A<<	6.	3.8V6 mark<3800>
>>A<<	7.	V6 mark<3000 GLX>
>>A<<	8.	DI-D mark<3200>
>>A<<	9.	GLS mark<GLS>

INSTALLATION SERVICE POINT

>>A<< MARK INSTALLATION

1.Installation position
Attach each mark to the position shown in the illustration.

3.Installation procedure
(1) Use 3M ATD Part number 8906 or equivalent to clean the mark installation surfaces on the body.
(2)

caution

When attaching the marks, the ambient temperature should be 20 - 38°C and the air should be completely free of dust. If the ambient temperature is lower than 20°C, the marks and the places on the vehicle body where the marks are to be attached should be heated to 20 - 30°C.

Peel off the protection sheet on the back of the marks to paste it on the installation position.
(3) Remove the application tapes on top of the marks.