|
Refer to the Disassembly Service
Point for FRONT BUMPER ().
|
|
Use the special tool ornament
remover (MB990784) to pry out the overfender.
|
|
Refer to the Reassembly Service
Point for FRONT BUMPER ().
|
|
1.Wipe the double-sided tape
application surface on the front/rear overfender and clean
it with a rag moistened with isopropyl alcohol.
|
|
2.Tear off the double-sided
tape backing paper of the front/rear overfender
pad.
|
|
3.Install the pad to the
overfender.
note |
If the double-sided tape is
difficult to affix in cold temperature, etc.,
warm the bonding
surfaces of the tape to about 40 -
60°C before affixing the tape.
|
|
|
4.Firmly press in the pad to
the overfender and body.
|
|
1. Installation
position 2.
caution |
- The ambient temperature should be 20
to 38°C. Ensure that the working
area is clean.
- If ambient temperature is less than
20°C, heat the protect film and
application
surface to a temperature of 20 to
30°C.
- Be careful that air bubbles are not
formed under the protect film.
|
Installation procedure (1)
Wipe the protect film application surface and clean it with
a rag moistened with isopropyl
alcohol. (2)
Remove backing paper from the protect film, and apply the
film to the specified position.
|
|
The procedure is the same as
removal and installation of side aid dam double-sided tape
(Refer to ).
|