Inspection Procedure 3: When the selector lever is moved to "R" position during the rear wiper operation, the rear wiper does not operate at the continuous mode.




caution Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.

COMMENTS ON TROUBLE SYMPTOM
If the rear wiper does not operate consecutively when the shift lever<M/T> or selector lever<A/T> is moved to the R position during the rear wiper operation, the input signal circuit to the back-up lamp switch ("R" position) <M/T>, inhibitor switch<A/T> or the ETACS-ECU may be defective.

POSSIBLE CAUSES

  • Malfunction of the back-up lamp switch <M/T>
  • Malfunction of the inhibitor switch <A/T>
  • Malfunction of the ETACS-ECU
  • Damaged harness wires and connectors

DIAGNOSIS PROCEDURE

Step 1. Rear wiper operation check
Check to see that the rear wiper operates normally with the rear wiper switch.

Q. Is the check result normal?
Go to Step 2.
Refer to Inspection procedure 1 "The rear wiper does not operate at all "

Step 2. SWS monitor data list.
Check the SWS communication signal, which are related to the R (reverse) gear-linked rear wiper operation.
Selected item REAR WIPER-REV. INTERLOCK
  • Ignition switch: ON
  • Rear wiper switch: ON
  • Shift position: R position
Item No.
 Item name
 Normal condition
Item 41
 INHIBITOR SW
 ON
OK: Normal condition is displayed.

Q. Is the check result normal?
Go to Step 3.
Refer to GROUP 54A - ETACS, Inspection procedure C-3 "The R position signal is not received "

Step 3. Retest the system.
Check that the rear wiper operates consecutively when the selector lever is moved to the R position during the rear wiper operation.

Q. Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).
Replace the ETACS-ECU.