Code No.B1427: Side impact sensor (RH) voltage error
![](../../../img/52/W7B52L004A00ENG.png)
![](../../../img/52/AC607571AL00ENG.png)
![](../../../img/52/AC607564AL00ENG.png)
![](../../../img/52/AC607652AC00ENG.png)
![](../../../img/52/AC607678AE00ENG.png)
caution |
If diagnosis code B1427 is set in the SRS-ECU, always
diagnose the CAN main bus line.
|
OPERATION
The side impact sensor transmits acceleration data to
the SRS-ECU. The SRS-ECU then determines. if the side and/or curtain air bags
should be inflated, and then sends an ignition signal. The side impact sensor
also diagnoses itself, and sends a diagnosis code to the SRS-ECU if a problem
occurs.
DIAGNOSIS CODE SET CONDITIONS
This diagnosis code will set when
the power supply voltage to the side impact sensor (front) (RH) remains less
than a predetermined value for one second.
PROBABLE CAUSES
- Damaged wiring harness or connectors
- Malfunction of the side impact sensor (front) (RH)
- Malfunction of the SRS-ECU
|
STEP 1. M.U.T.-III CAN bus diagnostics
|
|
Use the M.U.T.-III to diagnose the CAN bus
lines.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Repair
the CAN bus line (Refer to GROUP 54, Diagnosis ).
|
|
|
|
STEP 2. Check whether the diagnosis code is reset.
|
|
Check again if the diagnosis code is
set.
|
|
(1)Erase the diagnosis code.
|
|
(2)Ignition: "LOCK" (OFF) position to "ON"
|
|
(3)On completion, check that the diagnosis code is not
reset.
|
|
Q.
Is the diagnosis code set?
|
|
Go to Step 3.
|
|
|
|
There
is an intermittent malfunction such as poor engaged connector(s) or open
circuit (Refer to GROUP 00, How to Cope with Intermittent Malfunction ).
|
|
|
|
STEP 3. Check the harness wires for open circuit or short circuit
between SRS-ECU connector D-23 (terminal No.63 and 64) and side impact
sensor (front) (RH) connector E-28 (terminal No.1 and 2).
|
|
Q.
Are the harness wires between SRS-ECU connector D-23 (terminal No.63 and
64) and side impact sensor (front) (RH) connector E-28 (terminal No.1 and
2) in good condition?
|
|
Go to Step 4.
|
|
|
|
Replace the harness wires between
SRS-ECU connector D-23 (terminal No.63 and 64) and side impact sensor
(front) (RH) connector E-28 (terminal No.1 and 2).
|
|
|
|
STEP 4. Check the side impact sensor (RH).
|
|
(1)Disconnect the negative battery terminal.
|
|
(2)Replace the side impact sensor (front) (RH) with the side
impact sensor (front) (LH).
|
|
(3)Connect the negative battery terminal.
|
|
(4)Erase the diagnosis code from memory, and check the
diagnosis code.
|
|
Q.
Is diagnosis code B1427 set?
|
|
Replace the SRS-ECU (Refer to ).
|
|
|
|
Replace the side impact sensor (front)
(RH) with a new one (Refer to ).
|
|
|