Inspection Procedure 9: The Turn-signal Indicator Lamps does not
Illuminate.
caution
Whenever the ECU is replaced, ensure that
the input and output signal circuits are normal.
COMMENTS ON TROUBLE SYMPTOM
If the turn-signal indicator
lamps does not illuminate normally, connector(s), wiring harness in the
CAN bus lines, the ETACS-ECU or the combination meter may be
defective.
PROBABLE CAUSES
Malfunction of the CAN bus line
Malfunction of the combination meter
Malfunction of the ETACS-ECU
Damaged harness wires and connectors
DIAGNOSIS PROCEDURE
STEP 1. Check that the
hazard warning lamps operate.
Check that the hazard warning
lamps illuminate normally.
Q.
Is the headlamps in good condition?
Go to Step
2.
Refer to Hazard
Warning Lamp - Inspection Procedure 1 "The hazard warning lamps do
not illuminate normally ."
STEP 2. M.U.T.-III CAN bus diagnostics
Use
the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step
3.
Repair the CAN bus
line (Refer to GROUP 54D - Troubleshooting ).
STEP 3. M.U.T.-III actuator test
Perform
the actuator test for the combination meter, and check that the
turn-signal indicator illuminates (Refer to Combination Meter -
Troubleshooting ).