|
1.Measure the centre of the
front fog lamps, as shown in the
illustration. 2.Set the distance between the
screen and the centre of the front fog lamps as shown in the
illustration. 3.Inflate the types to the specified
pressures and there should be no other load in the vehicles
other than driver or substituted weight of approximately 75
kg placed in the driver’s position. 4.With
the engine running at 2,000 r/min, aim the front fog
lamp. 5.Insert a Phillips screwdriver into the
service hole and place it on the adjusting screw.
|
|
6.Adjust the cut off line
(boundary between light and dark) position to the standard
value with the adjusting screw. Standard
value: Vertical direction; 60 mm (1.15°) below
horizontal (H) Limit: Vertical
direction; 39 mm (0.75°) to 89 mm (1.7°)
below the horizontal (H)
note |
The horizontal direction is
non-adjustable.
|
|