Inspection Procedure 4: The Fog Lamp Indicator does not
Illuminate.
caution
Whenever the ECU is replaced, ensure that
the input and output signal circuits are normal.
COMMENTS ON TROUBLE SYMPTOM
If the front fog lamp indicator
or rear fog lamp indicator does not illuminate normally, connector(s),
wiring harness in the CAN bus lines, the ETACS-ECU or the combination
meter may be defective.
PROBABLE CAUSES
Malfunction of the CAN bus line
Malfunction of the combination meter
Malfunction of the ETACS-ECU
Damaged harness wires and connectors
DIAGNOSIS PROCEDURE
STEP 1. Check the
front fog lamps or rear fog lamp.
Check that the front fog
lamps or rear fog lamp illuminate normally.
Q.
Is the headlamps in good condition?
Go to Step
2.
Refer to Inspection
Procedure 1 "The front fog lamps do not illuminate normally ." or Inspection
Procedure 3 "The rear fog lamps do not illuminate normally ."
STEP 2. M.U.T.-III CAN bus diagnostics
Use
the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step
3.
Repair the CAN bus
line (Refer to GROUP 54D - Troubleshooting ).
STEP 3. M.U.T.-III actuator test
Perform
the actuator test for the combination meter, and check that the front
fog lamp indicator and rear fog lamp illuminates (Refer to Combination
Meter - Troubleshooting ).