Inspection Procedure 1: The Reversing Sensor System does not
Operate.
|
COMMENTS ON TROUBLE SYMPTOM
|
|
If the reversing sensor OFF indicator
illuminate when the ignition switch is turned to the "ON" position, the
power supply system is normal. The wiring harness, connectors, corner
sensor-ECU may be defective.
|
|
- Damaged harness wires and connectors
- Malfunction of corner sensor-ECU
- Malfunction of ignition switch (IG2)
|
|
STEP 1. Connector check: D-16 Corner sensor-ECU
connector.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Repair
the defective connector.
|
|
|
|
STEP 2. Voltage measurement at D-16 corner sensor-ECU connector in
order to power supply circuit to corner sensor-ECU (IG2 power
supply)
|
|
(1)Disconnect corner sensor-ECU connector D-16, and measure
at the wiring harness side.
|
|
(2)Turn the ignition switch to "ON" position.
|
|
(3)Measure the voltage between terminal No. 11 and
earth. OK: System voltage
|
|
Q.
Is the check result normal?
|
|
Go to Step 4.
|
|
|
|
Go to Step 3.
|
|
|
|
STEP 3. Check the wiring harness between D-16 corner sensor-ECU
connector terminal No. 11 and ignition switch (IG2).
|
|
note |
Before the wiring harness inspection, inspect
junction block connector D-403 and D-405,and joint connector D-34, and
repair if necessary.
|
|
|
Q.
Is the check result normal?
|
|
Retest
the system.
|
|
|
|
Repair
the wiring harness.
|
|
|
|
STEP 4. Resistance measurement at corner sensor-ECU connector D-16 in
order to the earth circuit to the corner sensor-ECU.
|
|
(1)Disconnect corner sensor-ECU connector D-16, and measure
at the wiring harness side.
|
|
(2)Measure the resistance between terminal No. 20 and
earth. OK: Continuity exists (2 Ω or less)
|
|
Q.
Is the check result normal?
|
|
Go to Step 6.
|
|
|
|
Go to Step 5.
|
|
|
|
STEP 5. Check the wiring harness between D-16 corner sensor-ECU
connector terminal No. 20 and earth.
|
|
Q.
Is the check result normal?
|
|
Retest
the system.
|
|
|
|
Repair
the wiring harness.
|
|
|
|
STEP 6. Verification after corner sensor-ECU replacement
|
|
After replacing the corner sensor-ECU, inspect
the reversing sensor system for normal operation.
|
|
Q.
Is the check result normal?
|
|
The
procedure is complete.
|
|
|
|
Replace the ignition switch.
|
|
|