|
Input signal from the column switch (wiper switch) is used to operate the functions below.
If the signal is abnormal, these functions will not work normally.
|
|
- Windshield wiper and washer
- Rear wiper and washer
|
|
- Malfunction of the column switch
- Damaged harness wires and connectors
|
|
Check that the wiper and washer switch connector, the lighting switch connector and the
switch body connector are in good condition.
|
|
Q.
Is the check result normal?
|
|
YES <LHD> : Go to Step 2.
|
|
|
|
YES <RHD> : Go to Step 3.
|
|
|
|
NO : Repair the defective connector.
|
|
|
|
- Check the continuity for wiper switch (Refer to ).
- Check the continuity for column switch (switch body part) (Refer to ).
|
|
Q.
Is the check result normal?
|
|
Replace the column switch.
|
|
|
|
Check that the ETACS-ECU sets a diagnosis code.
|
|
Q.
Is the diagnosis code set?
|
|
Refer to diagnosis code chart .
|
|
|
|
Replace the column switch, and check if the column switch (windshield wiper washer and
rear wiper washer switch) sends signal.
|
|
(1)Replace the column switch.
|
|
(2)Check if the column switch (windshield wiper/washer and rear wiper washer
switch) sends signal.
|
|
Q.
Is the check result normal?
|
|
The procedure is complete.
|
|
|