Code No.04 Communication Error with Sunroof-ECU
|
caution |
If diagnosis code No.04 is set in the ETACS-ECU, diagnose the CAN bus lines.
|
|
|
The ETACS-ECU communicates with the sunroof motor assembly (sunroof-ECU) through the SWS communication line. If there is any trouble in that communication, diagnosis code No.04 will be set.
|
|
note |
For vehicles without sunroof, diagnosis code No.04 does not mean that there is a problem.
|
|
|
COMMENTS ON TROUBLE SYMPTOM
|
|
The sunroof motor assembly (sunroof-ECU), the ETACS-ECU, connector(s), or wiring harness between the two may be defective.
|
|
- Malfunction of the sunroof motor assembly (sunroof-ECU)
- Malfunction of the ETACS-ECU
- Damaged harness wires and connectors
|
|
STEP 1. M.U.T.-III CAN bus diagnostics
|
|
Use the M.U.T.-III to diagnose the CAN bus lines.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Repair the CAN bus line (Refer to GROUP 54D - Troubleshooting ).
|
|
|
|
STEP 2. Check whether the diagnosis code is reset.
|
|
Check again if the diagnosis code is set.
|
|
(1)Erase the diagnosis code.
|
|
(2)Ignition switch: LOCK (OFF) position to ON
|
|
(3)On completion, check that the diagnosis code is not reset.
|
|
Q.
Is the check result normal?
|
|
If a trouble is solved, it is determined that there is an intermittent malfunction such as poor engaged connector(s) or open circuit (Refer to GROUP 00 - How to use troubleshooting/Inspection Service Points ).
|
|
|
|
Go to Step 3.
|
|
|
|
STEP 3. ECU check by using the SWS monitor
|
|
Check that the power supply and earth lines to the ETACS-ECU and the sunroof motor assembly (sunroof-ECU) and the SWS communication lines are normal.
|
|
OK: "OK" are displayed for all the items
|
|
Q.
Are the check result normal?
|
|
YES <Normal conditions are displayed for all the items.> : Intermittent malfunction (Refer to GROUP 00 - How to use troubleshooting/Inspection Service Points ).
|
|
|
|
NO <"NG" is displayed on the "ETACS ECU" menu.> : Refer to Inspection Procedure 2 "Communication with the ETACS-ECU is not possible ."
|
|
|
|
NO <"NG" is displayed on the "Sunroof ECU" menu.> : Refer to Inspection Procedure 5 "Communication with the sunroof motor assembly (sunroof-ECU) is not possible ."
|
|
|