Code No.10 Bus off
|
caution |
If diagnosis code No.10 is set in the ETACS-ECU, diagnose the CAN bus lines.
|
|
|
caution |
Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.
|
|
|
Diagnosis code No.10 will be stored when the ETACS-ECU ceases CAN communication (bus off) and then resumes the communication by turning the ignition switch to the "LOCK" (OFF) position.
|
|
COMMENTS ON TROUBLE SYMPTOM
|
|
The wiring harness wire or connectors may have loose, corroded, or damage terminals, or terminals pushed back in the connector, or the SWS communication lines may be defective.
|
|
Damaged harness wires and connectors
|
|
STEP 1. M.U.T.-III CAN bus diagnostics
|
|
Use the M.U.T.-III to diagnose the CAN bus lines.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Repair the CAN bus line (Refer to GROUP 54D - Troubleshooting ). On completion, go to Step 3.
|
|
|
|
STEP 2. Check whether the diagnosis code is reset.
|
|
Check again if the diagnosis code is set.
|
|
(1)Erase the diagnosis code.
|
|
(2)Ignition: LOCK (OFF) position to ON
|
|
(3)On completion, check that the diagnosis code is not reset.
|
|
Q.
Is the check result normal?
|
|
If a trouble is solved, it is determined that there is an intermittent malfunction such as poor engaged connector(s) or open circuit (Refer to GROUP 00 - How to use troubleshooting/Inspection Service Points ).
|
|
|
|
Replace the ETACS-ECU, and then go to Step 3.
|
|
|
|
STEP 3. Check whether the diagnosis code is reset.
|
|
Recheck if the diagnosis code is set.
|
|
(1)Erase the diagnosis code.
|
|
(2)Ignition switch: LOCK (OFF) position to ON
|
|
(3)On completion, check that the diagnosis code is not reset.
|
|
Q.
Is the check result normal?
|
|
The procedure is complete.
|
|
|
|
Return to Step 1.
|
|
|