Inspection
Procedure 2: Cool air does not come
|
If the blower air temperature can not be cool when turning A/C switch ON and
lowering the preset temperature, inadequate refrigerant quantity, sensors, harness or connectors
may be suspected.
|
|
- Damaged the wiring harness or connectors
|
|
STEP 1. Check the blower operation
|
|
(1)Turn the ignition switch to the ON position.
|
|
(2)Blower knob: Other than OFF
|
|
(3)Check that the air comes out of the blower.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Refer to Inspection Procedure 3 " Front blower does not work ".
|
|
|
|
STEP 2. Check the A/C compressor operation
|
|
Check that the compressor operates under the following conditions.
|
|
- Engine operation
- A/C switch: ON
- Temperature control dial: 18°C (MAX COOL)
|
|
Q.
Is the check result normal?
|
|
Go to Step 3.
|
|
|
|
Refer to Inspection Procedure 6 " The compressor does not work <4M40
M/T> " or Inspection Procedure 7 " The compressor does not work <4M40
A/T> " Inspection Procedure 8 " The compressor does not work <Except
for 4M40> ".
|
|
|
|
STEP 3. M.U.T.-III diagnosis code
|
|
Check that the diagnosis code related to the A/C is not set.
|
|
Q.
Is the check result normal?
|
|
Go to Step 4.
|
|
|
|
Carry out the diagnosis code procedures. Refer to .
|
|
|
|
STEP 4. Refrigerant level check
|
|
Check that the refrigerant level is adequate. Refer to .
|
|
Q.
Is the check result normal?
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent
Malfunction ).
|
|
|
|
Charge or remove the refrigerant level. Refer to .
|
|
|