INITIALISATION PROCEDURE FOR LEARNING VALUE IN COMMON RAIL ENGINE <Diesel>


INITIALISATION PROCEDURE
1.After the ignition switch is in the "LOCK" (OFF) position <except vehicles with KOS> (or put the power supply mode is OFF <vehicles with KOS>), connect M.U.T.-III with the diagnosis connector.
2.Ignition switch is in the "ON" position <except vehicles with KOS> (or put the power supply mode is ON <vehicles with KOS>).
3.Select "MPI/GDI/DIESEL" from System select Screen of the M.U.T.-III.
4.Select "Special Function" from MPI/GDI/DIESEL Screen.
5.Select "Initialisation" from Special Function Screen.
6.Select the item on the screen of the initialisation for learning, and perform the initialisation.
Service
 Item No.
 Item
At replacing supply pump *
 21
 Supply pump exchange service
At replacing EGR cooler
 53
 Fuel consumption initialized
note *: After Initialising the learning value, carry out the supply pump correction learning in order to replace the supply pump. (Refer to ).