|
1.Before inspection, set the
vehicle to the pre-inspection condition.
|
|
2.Turn the ignition switch
to the "LOCK" (OFF) position and then connect the M.U.T.-III
to the diagnosis connector (Refer to GROUP 00 -
Precautions Before Service, M.U.T.-III ).
|
![](../../../img/11/ACF01300AB00ENG.png)
|
3.Disconnect the ventilation
hose from the positive crankcase ventilation (PCV) valve,
and
connect a vacuum gauge to the ventilation
hose. 4.Plug the PCV valve. 5.Start the
engine and check that idle speed is approximately 650
r/min. 6.Check the intake manifold
vacuum. Limit: Minimum 60
kPa 7.Turn the ignition switch to the
"LOCK" (OFF) position. 8.Remove the vacuum gauge
and then connect the vacuum hose. 9.Disconnect the
M.U.T.-III.
|