![](../../../img/11/AC802013AB00ENG.png)
|
1.Use special tool flywheel
stopper (MB991883) to secure the flywheel
assembly. 2.Remove the flywheel bolts.
|
![](../../../img/11/AC102328AB00ENG.png)
|
1.Apply a small amount of
engine oil to the entire inner diameter of the oil seal
lip. 2.Use the following special tools to
press-fit the oil seal.
- Installer bar (MB990938)
- Crankshaft rear oil seal installer
(MD998776)
|
![](../../../img/11/AC802014AB00ENG.png)
|
1.Use special tool flywheel
stopper (MB991883) to secure the flywheel assembly in the
same
manner as removal. 2.Tighten the flywheel bolts to
the specified torque. Tightening torque: 133
±
4 N·m
|
![](../../../img/11/AC102329AC00ENG.png)
|
1.Apply a small amount of
engine oil to the entire inner diameter of the oil seal
lip. 2.Apply a small amount of engine oil to the
outer diameter of special tool crankshaft
front oil seal guide (MD998285) and install it to the
crankshaft. 3.Use special tool crankshaft front
oil seal installer (MD998375) to press-fit the oil
seal.
|
![](../../../img/11/AC211222AE00ENG.png)
|
1.Clean or degrease the
front case, the crankshaft and the crankshaft sprocket B as
shown.
note |
Also clean the degreased
surfaces.
|
2.Install the crankshaft sprocket B in the
direction shown in the illustration.
|