![](../../../img/11/AKX00561AE00ENG.png)
|
caution |
Keep the O-ring free of oil or
grease.
|
1.Attach a new O-ring to each end of the
water inlet pipe. 2.Wet the O-ring with
water. 3.Insert the front end of the pipe into the
thermostat housing.
|
![](../../../img/11/AK101822AB00ENG.png)
|
1.Apply a 3 mm diameter bead
of sealant Three bond 1207F or equivalent to the groove
as shown in the illustration. Specified
sealant: Three bond 1207F or
equivalent 2.Install the fitting quickly
(within 15 minutes) while the sealant is wet and tighten
the bolts to the specified torque of 23 ± 4
N·m.
note |
After installation, keep the
sealed area away from the coolant for
approximately one hour.
|
|
![](../../../img/11/AK101824AC00ENG.png)
|
1.Check that the rubber ring
is free from damage and seated correctly in the thermostat
flange. 2.Install the thermostat as shown in the
illustration. The jiggle valve must be at the
uppermost position.
|