REMOVAL AND INSTALLATION

			Removal steps
<<A>>	>>A<<	1.	Drive plate bolt
		2.	Adapter plate
		3.	Drive plate
		4.	Crankshaft adapter
		5.	Rear plate

REMOVAL SERVICE POINT

<<A>> DRIVE PLATE BOLT REMOVAL

1.Using special tool Flywheel stopper (MD998781), hold the drive plate.
2.Remove the drive plate bolt.

INSTALLATION SERVICE POINTS

>>A<< DRIVE PLATE BOLT INSTALLATION

1.Cleanly remove sealant, oil and dust on the drive plate bolt, the drive plate and the threaded portions of the crankshaft.

2.Apply oil to the drive plate and the seating surface of the drive plate bolt.
3.Apply oil to the threaded hole of the crankshaft
4.Apply sealant to the thread portions of the drive plate bolt.
Specified sealant:
Three bond 2403 or equivalent

5.Using special tool Flywheel stopper (MD998781), hold the drive plate.

6.Tighten drive plate bolt or flywheel bolt to temporary torque of 20 ± 2 N·m in the order shown to illustration.
7.Tighten drive plate bolt or flywheel bolt to specified torque of 76 ± 4 N·m in the order shown in the illustration.
8.Apply the engine oil to the thread portions and the sealed portions on the installation bolts.