REMOVAL AND INSTALLATION <6B3>

Pre-removal Operation

Engine Coolant Draining (Refer to ).

Post-installation Operation

Engine Coolant Refilling (Refer to ).

			Removal steps
		1.	Control wiring harness and battery wiring harness combination connector connection
		2.	Battery wiring harness connection
		3.	Harness bracket
<<A>>	>>B<<	4.	Radiator lower hose connection
		5.	Cooling water inlet hose fitting
	>>A<<	6.	Thermostat

REMOVAL SERVICE POINT

<<A>> RADIATOR LOWER HOSE DISCONNECTION

Make mating marks on the radiator hose and hose clamp as shown to install them in the original position. Then, remove them.

INSTALLATION SERVICE POINTS

>>A<< THERMOSTAT INSTALLATION

caution

Avoid adhesion of grease to the rubber ring of the thermostat. If the rubber ring is damaged, replace the thermostat.

Install the thermostat with care to avoid peeling or damage to the rubber ring. When installing the thermostat, face the jiggle valve of the thermostat upward.

>>B<< RADIATOR LOWER HOSE CONNECTION

1.Insert the radiator lower hose to the protrusion of the cooling water inlet hose fitting.
2.Align the mating marks on the radiator lower hose and hose clamp, and then connect the radiator lower hose.