REMOVAL AND INSTALLATION <4G6>


Pre-removal Operation
  • Under Skid Plate and Engine Room Under Cover Front Removal (Refer to GROUP 51 - Under Cover ).
  • Engine Coolant Draining (Refer to ).
  • Timing Belt and Timing Belt B Removal (Refer to GROUP 11A - Timing Belt ).

 Post-installation Operation
  • Timing Belt and Timing Belt B Installation (Refer to GROUP 11A - Timing Belt ).
  • Engine Coolant Refilling (Refer to ).
  • Under Skid Plate and Engine Room Under Cover Front Installation (Refer to GROUP 51 - Under Cover ).




Removal steps


1.
 Alternator adjusting brace


2.
 Water pump


3.
 Water pump gasket

>>A<<
 4.
 Cooling water line O-ring

INSTALLATION SERVICE POINT

>>A<< COOLING WATER LINE O-RING INSTALLATION
caution
  • Care must be taken not to permit engine oil or other greases to adhere to the cooling water line O-ring.
  • When inserting the water pump inlet pipe, check to be sure that there is no sand, dirt, etc. on its inner surface.

Fit the cooling water line O-ring to the groove in the water pump inlet pipe. Then lubricate the cooling water line O-ring and the inside of the water pump with water, and then insert the water pump inlet pipe to the water pump.