REMOVAL AND INSTALLATION <4D5>

Pre-removal Operation

Timing Belt and Timing Belt B Removal (Refer to GROUP 11G - Timing Belt ).
Thermostat Removal (Refer to ).

Post-installation Operation

Thermostat Installation (Refer to ).
Timing Belt and Timing Belt B Installation (Refer to GROUP 11G - Timing Belt ).

		Removal steps
	1.	Plate
	2.	Gasket
	·	Oil hose and oil pipe (Refer to GROUP 11G - Vacuum Pump ).
	3.	Water pump
	4.	Water pump gasket
>>A<<	5.	O-ring

INSTALLATION SERVICE POINT

>>A<< O-RING INSTALLATION

caution

Care must be taken not to permit engine oil or other greases to adhere to the O-ring.
When inserting the water pipe, check to be sure that there is no sand, dirt, etc. on its inner surface.

Fit the O-ring to the groove in the water pipe. Then lubricate the rim of O-ring or the inside of water pipe fixing position with water, and then insert the water pipe to the water pump.