|
1.Turn the ignition switch to the "LOCK" (OFF) position and then connect the M.U.T.-III to the diagnosis connector (Refer to GROUP 00 - Precautions Before Service, M.U.T.-III ).
|
|
2.Make sure the diagnosis codes are not set using M.U.T.-III. If set, record the code No. Carry out the troubleshooting for the set codes and solve the problems even if not related to the ignition.
|
|
3.Disconnect the injector connectors on all of the cylinders.
|
|
4.Disconnect the ignition coil connector.
|
|
5.Remove the ignition coil and install a good spark plug to the ignition coil.
|
|
6.Connect the ignition coil connector.
|
|
7.Earth the side electrode of the spark plug and crank the engine.
|
|
8.Check that spark is produced between the electrodes of the spark plug.
|
|
9.If the spark plug has weak sparks or no sparks, carry out the same check using a good ignition coil. If there are strong sparks on this check with a good ignition coil, it becomes clear there is a problem with the ignition coil. Replace the ignition coil with a new one. If there are no sparks on this check with a good ignition coil, there is probably a problem with the ignition circuit. Check the ignition circuit.
|
|
10.Using M.U.T.-III, make sure whether the diagnosis codes are set due to the check, or not. Except the codes set in Step 1, clear the codes all together if they are present. And then, carry out the troubleshooting about the codes recorded.
|
|
11.Turn the ignition switch to the "LOCK" (OFF) position, and then disconnect the M.U.T.-III.
|