|
1.Remove the cruise control
switch (Refer to ).
|
![](../../../img/17/ACG02442AB00ENG.png)
|
2.Measure the resistance
between terminal No. 7 and terminal No. 8 when each of the
ACC
distance switches is pressed. Measure the resistance between
terminal No. 5 and terminal No.
6 when each of the speed limiter ON/OFF, cruise
control ON/OFF, CANCEL, SET - and
RES + switches is pressed. If the values measured at
the time each switch is pressed correspond
to those in the table below, the resistance values are
correct.
|
Terminal connector
of tester
|
Switch
position
|
Specified
condition
|
7 - 8
|
ACC distance switch is
pressed
|
Continuity (less than
2Ω)
|
5 - 6
|
All switches are
released.
|
Open circuit
|
Speed limiter
ON/OFF switch is
pressed
|
Continuity (less than
2Ω)
|
ACC ON/OFF
switch is pressed
|
176.0 to
179.5Ω
|
CANCEL switch is
pressed
|
460.0 to
469.5Ω
|
SET - switch is
pressed
|
1,030.5 to 1,051.0
Ω
|
RES + switch is
pressed
|
2,725.0 to 2,836.5
Ω
|
|
3.Check that illumination of the cruise
control switch turns ON when the battery positive
terminal is connected to cruise control switch connector
terminal No. 3, and the battery negative
terminal is connected to cruise control switch connector
terminal No. 1.
|