|
Check for the continuity between
the connector terminals.
|
|
Switch
condition
|
Connector
terminals
|
Continuity
|
Switch end
pressed
|
1 - 2
|
Conductive
|
Switch end
released
|
1 - 2
|
Open
|
|
|
|
|
1.Combine the synchronizer
sleeve and hub, and check that they slide smoothly.
|
|
|
2.Check that the sleeve is
free from damage at its inside splines ends.
|
|
|
3.Using the thickness gauge,
check the clearance between the synchronizer ring and the
gear.
|
|
|
Standard value: 0.52
- 1.88 mm
Limit: 0.52 mm
|
|
|
1.Combine the needle roller
bearing with the shaft and gear, and check that it rotates
smoothly without noise or play.
|
|
|
2.Check the needle roller
bearing cage for deformation.
|
|
|
Inspect the thrust clearance of
counter shaft gear No.5.
|
|
|
Standard value: 0.10
- 0.35 mm
Limit: 0.35 mm
|
|
|
1.Fix the output shaft in a
vice.
|
|
|
2.Inspect the radial
clearance of counter shaft gear No.5.
|
|
|
Standard value: 0.015
- 0.068 mm
Limit: 0.068 mm
|
|
Using the cylinder gauge, check the
inside diameter of the counter shaft gear
No.5.
Standard value: 38.015 - 38.040
mm
Limit: 38.040 mm
|