DISASSEMBLY AND REASSEMBLY



Disassembly steps


1.
 Bracket

>>D<<
 2.
 Adapter case

>>C<<
 3.
 Oil seal


4.
 Pin


5.
 Pin


6.
 Change shifter


7.
 Snap ring


8.
 Bracket

>>B<<
 9.
 M/T case rear

>>A<<
 10.
 Bushing


11.
 Pin

REASSEMBLY SERVICE POINTS

>>A<< BUSHING INSTALLATION
Use special tools to install the bushing.

  • Installer adaptor (MB990926)
  • Installer bar (MB990938)

>>B<< M/T CASE REAR INSTALLATION

1.Completely degrease the FIPG-applied surface so that water and oil including the old sealant cannot adhere to the surface coated with the sealant.
Never touch the degreased surface by hand.
2.
caution Squeeze the sealant out evenly to apply it in an unbroken, non-excessive quantity.
Apply the sealant to the M/T case rear.
Specified sealant: THREEBOND 1216 or equivalent

>>C<< OIL SEAL INSTALLATION
1.Apply the specified lubricant to the oil seal lip.
Specified lubricant: MITSUBISHI MOTORS GENUINE part No. 0101011 or equivalent
2.Use special tool install the oil seal.

  • Installer adaptor (MB990933)
  • Installer bar (MB990938)

>>D<< ADAPTER CASE INSTALLATION

1.Completely degrease the FIPG-applied surface so that water and oil including the old sealant cannot adhere to the surface coated with the sealant.
Never touch the degreased surface by hand.
2.
caution Squeeze the sealant out evenly to apply it in an unbroken, non-excessive quantity.
Apply the sealant to the adapter case.
Specified sealant: THREEBOND 1216 or equivalent