|
If there is an ATF changer, use it.
If there is no ATF changer, replace the fluid as described
below.
|
![](../../../img/23/ACE03177AB00ENG.png)
|
note |
If you use an ATF changer,
disconnect the oil return hose from the oil
return tube. Then
connect the ATF changer between them.
|
|
![](../../../img/23/ACE02024AB00ENG.png)
![](../../../img/23/ACE02025AB00ENG.png)
![](../../../img/23/ACE02026AB00ENG.png)
|
1.
caution |
When draining the fluid from
the drain plug hole, use
a plate to prevent the fluid from dripping on
the centre member assembly.
|
Remove the filler plug and the drain plug, and drain
the fluid from the drain plug hole. Discharge
volume: Approx. 3.0 L 2.Install the drain
plug with a new gasket in between, and tighten it to the
specified
torque. Tightening torque: 20 ± 2
N·m 3.Remove the overflow
plug. 4.Pour in the fluid through the filler plug
hole until the fluid is drained from the
overflow plug hole. Wait until the fluid becomes oil drops,
and then tighten the overflow plug
with a new gasket and the filler plug with a new O-ring to
the specified torque. Tightening
torque:
20 ± 2 N·m
(overflow plug) 39 ± 15 N·m (filler
plug)
5.Check the fluid level
(refer to ). 6.During
the fluid level check, check the drained fluid for
contamination. If the fluid
is contaminated, perform steps 1 to 5 again.
|