|
|
1.Remove the drain plug
(overflow plug) and overflow tube and then drain fluid
(refer to  ).
|
|
2. Remove the transmission
oil pan, and remove the A/T fluid temperature sensor 1
from the valve body (refer to GROUP 23B - Oil Pan and
Valve Body Assembly Removal and Installation ).
| note |
A/T fluid temperature
sensor 1 is incorporated in the wiring
harness.
|
|
|
3.Immerse the sensor in hot
A/T fluid.
|
|
4.
| caution |
Be careful not to damage a
connector terminal.
|
Disconnect the A/T control solenoid valve
assembly connector.
5.Using the special tool
(MB991709), measure the resistance between A/T control
solenoid valve assembly connector terminals No.9 and
No.10.
Standard value:
Measurement terminal
No.
|
Normal condition (check
condition)
|
9
-10
|
Approx. 6.5 kΩ (at
10°C)
|
Approx. 3.5 kΩ (at
25°C)
|
Approx. 0.25 kΩ (at
110°C)
|
6.If the resistance is not the
standard value, replace the transmission wiring harness
(refer to GROUP 23B - Oil Pan and Valve Body Assembly
Removal and Installation ).
|
|
|
1.Disconnect the A/T
fluid temperature sensor 2 connector.
|
|
|
2.Remove the A/T fluid
temperature sensor (refer to ).
|
|
3.Immerse the sensor in hot
A/T fluid.
4.Measure the resistance between
the terminals of the A/T fluid temperature sensor
2.
Standard value:
657.1 -
726.3 kΩ (at 115°C)
584.8 -
646.4 kΩ (at 120°C)
339.5 -
375.3 kΩ (at 145°C)
277.9 -
307.1 kΩ (at
155°C)
5.If the resistance
deviates from the standard value greatly, replace the
A/T fluid temperature sensor 2.
|