REMOVAL AND INSTALLATION <2WD>


Pre-removal Operation
  • Under Skid Plate and Engine Room Under Cover Removal (Refer to GROUP 51 - Under Cover .)
  • A/T Fluid Draining (Refer to .)
  • Propeller Shaft Removal (Refer to GROUP 25 - Propeller Shaft .)
  • Exhaust Centre Pipe Connection (Refer to GROUP 17 - Catalytic Converter .)
  • Transmission Control Cable Connection Removal (Refer to .)
  • A/T Fluid Cooler Side Tube Assembly Removal (Refer to .)

 Post-installation Operation
  • A/T Fluid Cooler Side Tube Assembly Installation (Refer to .)
  • Transmission Control Cable Connection Installation (Refer to .)
  • Exhaust Centre Pipe Connection (Refer to GROUP 17 - Catalytic Converter .)
  • Propeller Shaft Installation (Refer to GROUP 25 - Propeller Shaft .)
  • A/T Fluid Supplying (Refer to .)
  • Under Skid Plate and Engine Room Under Cover Installation (Refer to GROUP 51 - Under Cover .)

<6B3>

Removal steps


1.
 Heat protector (rear)


2.
 Breather pipe assembly


3.
 Harness connector connection


4.
 Transmission sub wiring harness


5.
 Drive plate cover

>>A<<
 6.
 Drive plate connecting bolts


·
 Support the transmission with a transmission jack (Refer to GROUP 32 - Rear Engine Mounting .)


·
 No.2 crossmember and rear engine support insulator (Refer to GROUP 32 - Rear Engine Mounting .)
<<A>>
·
 Starter mounting bolt
<<B>>
·
 Supporting the engine (during removal)


7.
 Transmission assembly coupling bolts


8.
 Transmission assembly

<4N1>

Removal steps


1.
 Heat protector (rear)


2.
 Breather pipe assembly


3.
 Harness connector connection


4.
 Transmission sub wiring harness


5.
 Bell housing cover


6.
 Drive plate connecting bolts


·
 Support the transmission with a transmission jack (Refer to GROUP 32 - Rear Engine Mounting .)


·
 No.2 crossmember and rear engine support insulator (Refer to GROUP 32 - Rear Engine Mounting .)
<<A>>
·
 Starter mounting bolt
<<B>>
·
 Supporting the engine (during removal)


7.
 Transmission assembly coupling bolt (engine side)


8.
 Transmission assembly coupling bolts


9.
 Transmission assembly

REMOVAL SERVICE POINT

<<A>> STARTER MOUNTING BOLT REMOVAL
Remove the starter with its connector connected. Keep the starter fixed to the engine side (Refer to GROUP 16 - Starter Motor Assembly ).

<<B>> SUPPORTING THE ENGINE

caution Support the engine assembly by inserting a wooden piece between the front suspension front crossmember assembly and the engine oil pan to prevent the engine assembly from being tilted significantly when the transmission assembly is separated from the engine assembly.

INSTALLATION SERVICE POINT

>>A<< TRANSMISSION ASSEMBLY COUPLING BOLTS INSTALLATION <6B3>
The sizes of the mounting bolts are different. So be sure not to confuse them.

Bolt
 d × l mm
A
 10 × 50
B
 10 × 60
C
 10 × 65