REMOVAL AND INSTALLATION

caution

*: Indicates parts which should be temporarily tightened, and then fully tightened with the vehicle on the earth in an unladen condition.

Post-installation Operation

Check the beam direction of the headlamp (Low beam) (Refer to GROUP 54A - Headlamp Aiming ). <Vehicles with headlamp automatic levelling system>

		Removal steps
	·	Height sensor (rear) (Refer to GROUP 54A, Headlamp Automatic Levelling System .) <Vehicles with headlamp automatic levelling system>
	1.	Shock absorber <Left side only> (Refer to )
	2.	Bracket
	3.	Bushing
>>A<<	4.	Stabilizer bar side link kit
	5.	Stabilizer bar

INSTALLATION SERVICE POINT

>>A<< STABILIZER BAR SIDE LINK KIT INSTALLATION

1.To install the stabilizer bar, assemble the joint cups and rubber bushings by the order and the specified direction as shown in the figure.
2.Install the lower nut on the stabilizer bar mounting bolt to the specified dimensions.
Standard value (A): 31.3 - 33.3 mm
3.Tighten the upper nut to the specified torque.
Tightening torque: 42 ± 8 N·m