REMOVAL AND INSTALLATION

caution

*: Indicates parts which should be temporarily tightened, and then fully tightened with the vehicle on the earth in an unladen condition.

Pre-removal Operation

Support the rear axle assembly with a jack

Post-installation Operation

Brake Fluid Filling and air bleeding (Refer to GROUP 35A, On-vehicle Service ).
Check the beam direction of the headlamp (Low beam) (Refer to GROUP 54A - Headlamp Aiming ). <Vehicles with headlamp automatic levelling system>

	1.	Rear suspension spring bump stopper
		Coil spring removal steps
	·	Height sensor (rear) (Refer to GROUP 54A, Headlamp Automatic Levelling System .) <Vehicles with headlamp automatic levelling system>
	2.	Brake hose (LH)
	3.	Brake hose (RH)
	4.	Rear wheel speed sensor cable/parking brake cable to lower arm connection bolt
	5.	Lateral rod mounting bolt (Vehicle side only)
	6.	Shock absorber mounting bolt (Lower side only)
>>A<<	7.	Stabilizer bar side link kit
	8.	Coil spring
	9.	Upper pad

INSTALLATION SERVICE POINT

>>A<< STABILIZER BAR SIDE LINK KIT INSTALLATION

1.To install the stabilizer bar, assemble the joint cups and rubber bushings by the order and the specified direction as shown in the figure.
2.Install the lower nut on the stabilizer bar mounting bolt to the specified dimensions.
Standard value (A): 31.3 - 33.3 mm
3.Tighten the upper nut to the specified torque.
Tightening torque: 42 ± 8 N·m