REMOVAL AND INSTALLATION


Pre-removal Operation
  • Brake Fluid Draining

 Post-installation Operation
  • Brake Fluid Supplying and Air Bleeding (Refer to ).
  • Brake Pedal Adjustment (Refer to ).





Removal steps


1.
 Brake fluid level switch connector


2.
 Brake master cylinder assembly and brake pipe connection


3.
 Harness clip <6B3>


4.
 Harness bracket <6B3>


5.
 Brake master cylinder assembly


6.
 O-ring

>>C<<
 7.
 Vacuum hose (A) (with built-in check valve)

>>C<<
 8.
 Hose clip

>>B<<
 9.
 Vacuum hose (B)

>>B<<
 10.
 Hose clip


11.
 Vacuum hose


12.
 Hose clip

>>B<<
 13.
 Vacuum hose (C) <4N1>

>>B<<
 14.
 Hose clip


15.
 Vacuum pipe


16.
 Clamp

>>A<<
 17.
 Fitting <4G6>


18.
 Snap pin


19.
 Clevis pin


20.
 Brake booster mounting nut


21.
 Sealer


22.
 Brake booster assembly

INSTALLATION SERVICE POINTS

>>A<< FITTING INSTALLATION

Apply a sealant as shown.

>>B<< VACUUM HOSE (C) <4N1>, (B) <4G6, 6B3> AND HOSE CLIP INSTALLATION


<4G6, 6B3>
  1. Install the vacuum hose (B) with its marking located as shown in the figure.
  2. Install the hose clip located as shown in the figure.

<4N1>
  1. Install the vacuum hose (C) and vacuum hose (B) with its marking located as shown in the figure.
  2. Install the hose clip located as shown in the figure.

>>C<< VACUUM HOSE (A) (WITH BUILT-IN CHECK VALVE) AND HOSE CLIP INSTALLATION

1.Install the vacuum hose (A) (with built-in check valve) with its marking located as shown in the figure.
2.Install the hose clip located as shown in the figure.