REMOVAL AND INSTALLATION <4D5, 4N1>


Pre-removal Operation
  • Brake Fluid Draining

 Post-installation Operation
  • Brake Fluid Supplying and Air Bleeding (Refer to ).
  • Brake Pedal Adjustment (Refer to ).





Removal steps


1.
 Brake fluid level switch connector


2.
 Brake master cylinder assembly and brake pipe connection

>>A<<
 3.
 Hose clip

>>A<<
 4.
 Vacuum hose (with built-in check valve)


5.
 Harness clip


6.
 Harness bracket


7.
 Fuel pipe bracket


8.
 Brake master cylinder assembly


9.
 O-ring


10.
 Hose clip


11.
 Vacuum hose


12.
 Clamp


13.
 Vacuum hose


14.
 Snap pin


15.
 Clevis pin


16.
 Brake booster mounting nut


17.
 Sealer


18.
 Brake booster assembly

INSTALLATION SERVICE POINTS


>>A<< VACUUM HOSE (WITH BUILT-IN CHECK VALVE) AND HOSE CLIP INSTALLATION

<4D5>
  1. Install the vacuum hose (with built-in check valve) with its marking located as shown in the figure.
  2. caution Fit the hose clip as shown, and then allow clearance (C) so that the hose does not touch the EGR valve connector.
    Install the hose clip located as shown in the figure.

<4N1>
  1. Install the vacuum hose (with built-in check valve) with its marking located as shown in the figure.
  2. Install the hose clip located as shown in the figure.