REMOVAL AND INSTALLATION


Pre-removal operationBrake Fluid Draining
 Post-installation operation
  • Brake Fluid Supplying and Air Bleeding (Refer to ).
  • Parking Brake Lining Seating Procedure (Refer to GROUP 36 - Parking Brake Lining Seating Procedure ).




Removal steps


1.
 Brake tube (brake hose side) connection


2.
 Clip


3.
 Brake hose


4.
 Rear brake caliper assembly


·
 Brake disc run-out check and correction (only at installation) (Refer to ).

>>A<<
 5.
 Rear brake disc

>>A<<
 6.
 Plug
note The removal and installation for the drum brake (refer to GROUP 36 - Parking Brake Lining and Drum Removal and Installation ).

INSTALLATION SERVICE POINTS


>>A<< PLUG/REAR BRAKE DISC INSTALLATION
caution Align the plug hole on the rear brake disc with one of the four holes on the axle shaft. If you install the plug to the concave portion on the axle shaft by mistake, the plug will be adrift and the brake shoe cannot be adjusted.

1.Ensure that the plug hole on the rear brake disc is aligned with one of the four holes on the axle shaft.
2.Install the rear brake disc.
3.Install the plug.