BRAKE PAD REPLACEMENT




caution When replacing, replace both brake pads (right and left) as a set.

1.Remove the parts indicated in the figure, swivel the caliper body upward and retain it with a wire or similar tool.
2.Remove the following parts from the caliper body.
(1) Shim
(2) Shim cover
(3) Brake pad assembly
(4) Clip

3.
caution Keep grease or other soiling off the pad and brake disc friction surfaces.
Clean the piston part, and press the piston into the cylinder using the special tool piston expander (MB990520).
4.Assemble the shim, shim cover, brake pad assembly and clip to the caliper support, and tighten the pin bolt to the specified torque.
Tightening torque:
27 ± 4 N·m <16 inch>, 88 ± 5 N·m <17 inch>
note Install the brake pad assembly (with wear indicator) to the inner side of the brake disc, making sure that the wear indicator is located on the bottom.

LUBRICATION POINT


<16 inch>

<17 inch>