REMOVAL AND INSTALLATION


note The ABS-ECU is integrated in the hydraulic unit.
Pre-removal Operation
  • Brake Fluid Draining
  • Air cleaner removal (Refer to GROUP 15, Air Cleaner .)

 Post-installation Operation
  • Brake Fluid Filling
  • Air cleaner installation (Refer to GROUP 15, Air Cleaner .)
  • Brake Line Bleeding (Refer to GROUP 35A, On-vehicle Service - Bleeding .)
  • Hydraulic Unit Check (Refer to .)




Removal steps


1.
 Harness connector

>>A<<
 2.
 Brake tube and hydraulic unit assembly connection


3.
 Brake tube (MP)


4.
 Brake tube (MS)


5.
 Hydraulic unit assembly and hydraulic unit bracket assembly


6.
 Insulator


7.
 Collar
<<A>>
8.
 Hydraulic unit assembly (integrated with ABS-ECU)


9.
 Hydraulic unit bracket assembly

REMOVAL SERVICE POINT

<<A>> HYDRAULIC UNIT ASSEMBLY (INTEGRATED WITH ABS-ECU) REMOVAL
caution
  • The hydraulic unit assembly is heavy. Use care when removing it.
  • The hydraulic unit cannot be disassembled. Never loosen its nuts or bolts.

  • Do not drop or shock the hydraulic unit.

  • Do not turn the hydraulic unit upside down or lay it on its side.

INSTALLATION SERVICE POINT

>>A<< BRAKE TUBE CONNECTION

1.Connect the tubes to the hydraulic unit assembly as shown in the illustration.

  1. From the master cylinder (primary)
  2. From the master cylinder (secondary)
  3. To the front brake (LH)
  4. To the rear brake (RH)
  5. To the rear brake (LH)
  6. To the front brake (RH)

2.Install the clips to the brake tube as shown in the illustration.