Code No.C1707: Implausible coding data
| caution |
- If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C - Troubleshooting
 ).
- Whenever ECU is replaced, ensure that the CAN bus lines are normal.
- When diagnosis code No.C1707 is set in FCM-ECU, the diagnosis code may also be set in ETACS-ECU. When the diagnosis code is set in ETACS-ECU, perform the diagnosis of the diagnosis code for ETACS-ECU first.
- When the FCM-ECU is replaced, calibrate the radar (refer to ).
|
OPERATION
FCM-ECU receives the vehicle information stored in ETACS-ECU via CAN bus lines.
DIAGNOSIS CODE SET CONDITION
This diagnosis code is set when the abnormality below is detected:
- The vehicle information received from ETACS-ECU is not correct.
| note |
A diagnosis code is not set as a historic fault.
|
PROBABLE CAUSES
- The CAN bus line is defective.
- Malfunction of the ETACS-ECU
- Malfunction of the FCM-ECU
- ETACS-ECU has been interchanged between two vehicles.
|
|
STEP 1. M.U.T.-III CAN bus diagnostics.
|
|
|
Use M.U.T.-III to diagnose the CAN bus lines.
|
|
|
Q.
Is the check result normal?
|
|
|
 Go to Step 2.
|
|
|
|
|
|
 Repair the CAN bus lines (Refer to GROUP 54C - Troubleshooting ). On completion, go to Step 2.
|
|
|
|
|
|
STEP 2. Use M.U.T.-III to confirm a diagnosis code of other systems.
|
|
|
Check if the diagnosis code is set in the ETACS-ECU (Refer to GROUP 54A - Diagnosis Code Chart ).
|
|
|
Q.
Is the diagnosis code set?
|
|
|
Troubleshoot the ETACS-ECU diagnosis code (Refer to GROUP 54A - Diagnosis Code Chart ).
|
|
|
|
|
|
Go to Step 3.
|
|
|
|
|
|
STEP 3. Check the part number of ETACS-ECU
|
|
|
Check the part number of ETACS-ECU.
|
|
|
Q.
Is the check result normal?
|
|
|
Go to Step 4.
|
|
|
|
|
|
Replace the ETACS-ECU (Refer to GROUP 54A - ETACS-ECU ).
|
|
|
|
|
|
STEP 4. Check whether the diagnosis code is set again.
|
|
|
Check again if the diagnosis code is set in the FCM-ECU.
|
|
|
(1)Erase the diagnosis code.
|
|
|
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
|
|
|
(4)On completion, check that the diagnosis code is set again.
|
|
|
Q.
Is diagnosis code No. C1346 set?
|
|
|
Replace the FCM-ECU (Refer to ).
|
|
|
|
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunctions ).
|
|
|
|